UPS – Access Power Systems

APS9110E UPS Series

Key Features:

APS Outdoor Intelligent High Frequency Online UPS provide continuous pure sine wave AC power supply for outside communications / network equipment.
Double-conversion online design, high temperature resistant, anti-cold, sealing level for IP55; with the wide range of input voltage and frequency of input window 45% +35% rated voltage and ± 10% rated frequency), in many remote areas of China after a severe test of the grid.

Application This UPS is commonly used in the corner of the city, remote roads, mountains, bad environment, such as high temperature (+50 °C) / low temperature (-40 °C), severe dust, moisture, rain, mist erosion, very poor power quality (voltage longterm higher than 260V or less than 160V, frequency abnormal change) in the area. High Reliability of the UPS System

Using microprocessor control, directly produce high frequency pulse width modulation wave (SPWM) control of the UPS inverter, to simplify the UPS control circuit, to improve the stability, to have more real-time UPS to quickly respond to changes in the external environment and guarantee the machine’s control circuit is more simple and reliable.
Using digital control techniques, to avoid the traditional analog control temperature drift inherent defects such as hardware parameters, to ensure consistency and reliability of UPS.

Model	1-10KVA
Nominal voltage	220/230/240VAC
Output Power factor	0.7/0.8

Add to cart

APS9115C/APS9315C UPS series

Key Features

Its cutting digital technology of DSP (Digital Signal Processor) can greatly improve the products performance and system reliability, and deliver a compact integration
With higher power density Output power factor up to 0.8 – applicable to the tendency of future load evolution, and deliver high payload capacity
Total power factor up to 90% can minimize the power loss of UPS and save utilization cost for user;
Emergency Power Off (EPO): UPS can be instantly shut off in case of any emergency;
Compliance with EMC requirements of IEC61000-4, provide your device a clean electric environment.
Active power factor correction (PFC) technology allows the input power factor approaching to 1, dramatically reducing the immunity on utility grid
Excellent input frequency range makes UPS suitable to different power supply devices, i.e. generator set
Parallel Kit: realize the parallel extension and redundancy function, offer more flexibility and safety for user’s power supply planning;
Compact Design, Lower Noise

Model	APS9315C 10-20KVA (3Ph in/1Ph out)
Nominal voltage	380/400/415VAC (10-20KVA)
Output Power factor	0.8/0.9(Optional)

Add to cart

APS9116C UPS series

Key Features:

Large blue backlight LCD for detailed real-time UPS status display.
Pure sine wave double conversion online UPS with voltage regulator circuit, which can provide a perfect power protection when UPS working in a harsh surroundings.
Comprehensive electric isolation and bypass protection.
Input PFC technology, reduce harmonic pollution to the power grid.
Automatic alarm; Self-testing function
Wide Input frequency range can connect various fuel generator.
Adopt intelligent battery management, saving charging time and extend battery life.
DC start when power off, convenient and reliable; restart automatically when electricity is restored.

Model	1-3KVA
Nominal voltage	208/220/230/240VAC
Output Power factor	0.7/0.8（Optional）

Add to cart

APS9116C/APS9316C UPS series

Key Features:

Large blue black light LCD for detailed real-time UPS status display
Advanced online pure sine wave power supply system, with bypass maintain switch, It can provide a reliable, high quality AC power source to the precision equipments, can be used widely in different fields.
Widely used to computer equipments, telecommunication systems and industrial automatic control equipments.
Truly online design, it can adjust the input voltage, filtering, when the AC break off, the UPS will provide an uninterruptible power source from the backup batteries.
UPS will change to bypass mode when overloading or inverter fault, when over-loading remove, UPS will turn to inverter mode automatically.
N+X Parallel Redundancy and Capacity expansion for 6K-20K（up to three units)

Model:	6-20KVA
Nominal voltage	208/220/230/240VAC
Output Power factor	0.7/0.8（Optional）
Nominal frequency	50/60Hz

Add to cart

APS9312C /APS9332C UPS series

MINIMUM IMPACT ON SUPPLIES EASY SOURCE:

Input current distortion <4% for the 9312C/9332C with filter with sinusoidal absorption to remove the risk of resonance with other input supply users or phase shift capacitor sets. The absorbed current distortion is independent of input supply parameters such as impedance. This enables 9312C/ 9332C to deliver maximum performance levels regardless of the installation environment.

MAXIMUM BATTERY CARE:

Battery deep discharge protection;
Temperature compensating charger;
Built-in automatic and manual battery test feature.

SIMPLE TO INSTALL:

Capability to install the UPS into any distribution system (Neutral not required on rectifier input);
Capability to separate the rectifier/bypass power network and to power these from two separate sources, without Galvanic isolation (Necessary on UPS without an output transformer).

HIGH RELIABILITY:

Extremely high short-circuit current to ensure compatibility with the most difficult transformer applications (lighting, drives and industrial processes) and an isolation transformer on the inverter output;
Full microprocessor control with no-break static and manual by-passes

MAXIMUM RELIABILITY AND AVAILABILITY: Connect up to 6 units in parallel or N+1 redundancy, even of different power ratings. The UPS continue to work in parallel even if one of the interconnecting communication cables is disconnected (CLOSED LOOP). LOW CONSUMPTION LEVELS: APS9312C/APS9332C can achieve efficiencies >98% thanks to selectable Economy Mode which can be used in stable electrical environments to provide power supply continuity when the mains fail.

Model	APS9312C 10-100KVA (3Ph/1Ph) APS9332C 10-200KVA (3Ph/3Ph)
Output Power Factor:	0.8
Nominal Input Voltage	380/400/415VAC
Parallel	Maximum 8PCS UPS 10-200KVA (3 Ph in/1Ph out & 3 Ph in/3Ph out)

Add to cart

APS9335 UPS series

Features:

Superior energy saving and environment-friendly:

Efficiency > 96% at 50%-75% rated load, and > 95% at 25% rated load; Input PF > 0.99, input THDi<3%

Superior capability of powering load:

Output PF is 0.9, no need of power duration with load of leading or lagging PF

Easy-to-install:

Top or bottom cabling, no need of input cabling cabinet

Easy-to-maintain:

Full front access, UPS, failed part can be replaced shortly

Easy-to-modify:

The number of battery cells can be configured flexibly, so the original batteries can be used when modifying the legacy system; moreover, the battery cell can be replaced in time when it fails without interrupting the normal operation of UPS.

6-inch extra large LCD that can display 12 l a n g u a g e (English, Chinese , Russian, French, Spanish and so on)

Static switch module:

System standard configuration module
Adopt SCR and AC contactor in parallel
High reliability, strong overloads ability: 1000% for 1min
Transfer time less than 4ms
Have strong self-test, inter-lock and full-protection function

Power module:

Freedom choice of capacity configuration according demand, easy to expand
Online double-conversion design to ensure the output quality
Each module has independent digital intelligent control
Each module can work independently
Each module has a separate charging system
All modules can be hot-swappable, easy for online maintenance

Model	10-300KVA
Nominal voltage	380/400/415VAC
Output Power factor	0.9
Nominal frequency	50/60Hz

Add to cart

APS9335C UPS

Key Features:

Use advanced 6th generation DSP and full digital control technologies to realize higher system stability.
Output power factor is 0.9, carrying capacity than conventional UPS with 10% above, as users reduce investment cost.
Advanced distributed active parallel technology can realize parallel operation of 6PCS UPS units without the need of centralized bypass cabinet.
6-inch extra large LCD that can display 12 languages (English, Chinese, Russian, Spanish, French and so on)
Extra wide input voltage and frequency range make it adapt to severe power grid environment.
Intelligent battery management maintains battery automatically to prolong the battery life.
Standard input/output filter improves the system EMC performance.
Extra strong capability to withstand output overload and short circuit, ensuring the system stability and system safety under extreme conditions.

Model	120-800KVA
Nominal voltage	380/400/415VAC
Output Power factor	0.9
Indicated language	12 types (En.Ru.Sp.Fr…)
Nominal frequency	50/60Hz
Parallel	maximum 6PCS UPS
Efficiency Rate of Machine	≥94% (≥98% in ECO Mode)